5T Polyester Duplex Layer Flat Webbing Lifting Sling With Reinforced Eyes EN1492-1SF 7:1

5T Polyester Duplex Layer Flat Webbing Lifting Sling With Reinforced Eyes EN1492-1SF 7:1

Product Name Polyester webbing sling Material 100% high tenacity polyester Width 25mm-300mm Length From 1m to 20m up, can be customized as required W.L.L. From 1Ton to 12 Ton or up Safety Factor 4:1,5:1,6:1,7:1 all available Layer Single ply, double ply, three ply and four ply Color According to EN standard or as required Standard According to Machinery Directive 2006/42/EC and EN1492-1:2008+A1
Product description

5T Polyester Duplex Layer Flat Webbing Lifting Sling With Reinforced Eyes EN1492-1SF 7:1


ALWAYS:

· Store and handle webbing sling correctly.

· Inspect webbing sling and accessories before use and before placing into storage.

· Follow safe slinging practices, as given overleaf.

· Position the bight for choke lift at 120° (natural angle).

· Position the sling so that the load is uniformly spread over its width and protect the sling from sharp edges.

· Apply the correct mode factor for the slinging arrangement.


NEVER:

· Attempt to shorten, knot or tie webbing sling.

· Expose webbing sling to direct heat or flames.

· Use webbing sling at temperatures above 80°C or below 0°C without consulting the supplier.

· Expose webbing sling to chemicals without consulting the supplier.

· Shock load webbing sling.

· Use webbing sling which are cut or which have loose or damaged stitching.

· Use a sling with a missing/damaged label or illegible markings


Selecting the Correct Sling:

Webbing sling are available in a range of materials and sizes in single leg and endless sling forms. Select the sling to be used and plan the lift taking the following into account:

Material - polyester identified by a blue label is resistant to moderate strength acids but is damaged by alkalis; polyamide (Nylon) identified by a green label is virtually immune to alkalis but is damaged by acids; and polypropylene identified by a brown label is little affected by acids or alkalis but is damaged by some solvents, tars and paints and therefore, suitable for appliances where the highest resistance to

chemicals other then solvents is required.

Capacity - the sling must be both long enough and strong enough for the load and the slinging method.

Apply the mode factor for the slinging method.

For use at temperatures exceeding 80°C or below 0°C refer to the suppliers instructions.

For flat woven slings made to BS EN 1492-1:2000 + A1: 2008

Polyester And Polyamide -40ºC to 100º

Polypropylene -40ºC to 80ºC

Ranges vary in a chemical environment, in which case the advice of the manufacturer or supplier should be sought.

If the slings are used in multi-leg arrangement the angle formed between the legs should not be less than 30° or greater than 90°.

If abrasion, heat generated by friction or cutting from edges or corners are likely select a sling fitted with protective sleeves and/or use suitable packing.

Slings with grade 8 fittings and multi-leg slings with grade 8 master links should not be used in acidic conditions. Contact with acids or acidic fumes causes hydrogen embrittlement to grade 8 materials. If exposure to chemicals is likely, the manufacturer or supplier should be consulted.


Storing and Handling webbing sling

Never return wet, damaged or contaminated slings to storage. They should be cleaned with clear water and dried naturally. Never force dry webbing sling.

Store webbing sling hung from non-rusting pegs which allow the free

circulation of air.

The storage area should be dry, clean, free of any contaminates and shaded from direct sunlight.

Do not alter, modify or repair a webbing sling but refer such matters to a Competent Person.


NOTE: The material from which the sling is manufactured may be identified by the colour of the label or printing on the label: Polyester = Blue, Polyamide (Nylon) = Green, Polypropylene = Brown and the sling

may also be dyed with a colour code to indicate SWL.


Using Webbing Sling Safely

Do not attempt lifting operations unless you understand the use of the equipment, the slinging procedures and the mode factors to be applied.

Do not use defective slings or accessories.

Check the correct engagement with fittings and appliances, ensure smooth radii are formed, do not twist or cross sling and do not overcrowd fittings.

Position the sling so that the load is uniformly spread over its width.

Position the bight for a choke lift at the natural (120°) angle to prevent friction being generated.

Ensure that stitching is in the standing part of the sling away from hooks and other fittings.

Take the load steadily and avoid shock loads.

Do not leave suspended loads unattended. In an emergency cordon off the area.


In-service Inspection and Maintenance:

Maintenance requirements are minimal. Webbing sling may be cleaned with clear water. Remember weak chemical solutions will become increasingly stronger by evaporation.

Before each use inspect webbing sling and, in the event of the following defects, refer the sling to a Competent Person for thorough examination: illegible markings; damaged, chaffed or cut webbing; damaged or loose stitching; heat damage; burns; chemical damage; solar degradation; damaged or deformed end fittings


THE SPECIFICATION OF LITING SLING

SAFETY FACTOR (4:1;5:1;6:1;7:1 ) ,key factor for price & quality of lift sling.Kindly check the below:

W.L.L (Work Load Limit)Safety FactorWidthColor
1T7:130MMPurple
2T7:160MMGreen
3T7:190MMYellow
4T7:1120MMGrey
5T7:1150MMRed
6T7:1180MMBrown
8T7:1240MMBlue
10T7:1300MMOrange
12T7:1300MMOrange


W.L.L (Work Load Limit)Safety FactorWidthColor
1T4:1/5:1/6:125MMPurple
2T4:1/5:1/6:150MMGreen
3T4:1/5:1/6:175MMYellow
4T4:1/5:1/6:1100MMGrey
5T4:1/5:1/6:1125MMRed
6T4:1/5:1/6:1150MMBrown
8T4:1/5:1/6:1200MMBlue
10T4:1/5:1/6:1250MMOrange
12T4:1/5:1/6:1250MMOrange



Packing:

Packing: Gunny bag or carton case and pallet or other customized
Shipping: by ship or by air
Sample: Free but the freight
Payment: 30% payment in advance
Load port: Tianjin or other ports in China


Our Serives:

1.Client

We treasure and try to understand all the different needs of our clients and seek to forge a long term professional relationship with them. The satisfaction of each and every customer is our main goal and motivation in conducting our business.

2. People

We work as a team and treat each other with respect. Our solid, capable and knowledgeable team is valued as the greatest asset and an integral part of the business.

3. Product

Our products are of HIGH quality standards and always come with certificate of compliance by the manufacturers.

4. Performance

We aim to achieve high level of performance and satisfaction to both our client and people, which include delivering high quality services and treating people with integrity.

5. Free sample and OEM service

We can provide free samples to you and we also have OEM service, we can put your logo on the label and the information you need on the webbing too.


Welcome to your kindly inquiry!!!If you are interested in our products,pls let me know.


Should you're interested in the 5T Polyester Duplex Layer Flat Webbing Lifting Sling With Reinforced Eyes EN1492-1SF 7:1 made in China, welcome to wholesale the CE, TUV and GS approved product with our professional manufacturers and suppliers. And the customized service is also available in our factory.
Hot Tags: 5T Polyester Duplex Layer Flat Webbing Lifting Sling With Reinforced Eyes EN1492-1SF 7:1, China, manufacturers, suppliers, factory, wholesale, customized, CE TUV GS approved, made in China
Related Products
Feedback

Copyright © Hebei Jili Rigging Co.,Ltd All rights reserved.Tel: +86-312-6787976